Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
75606A
1.INSTALL QUARTER OUTSIDE MOULDING SUB-ASSEMBLY LH
When installing the quarter outside moulding sub-assembly LH, heat the vehicle body and quarter outside moulding sub-assembly LH using a heat light.
| Item | Temperature |
|---|---|
| Vehicle Body | 40 to 60°C (104 to 140°F) |
| Quarter Outside Moulding Sub-assembly LH | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Clean the vehicle body surface.
Using a heat light, heat the vehicle body surface.
Remove the double-sided tape from the vehicle body.
Wipe off any tape adhesive residue with cleaner.
Install a new quarter outside moulding sub-assembly LH.
Using a heat light, heat the vehicle body.
Remove the peeling paper from the face of the double-sided tape.
After removing the peeling paper, keep the exposed adhesive free from foreign matter.
Attach the clip to install the quarter outside moulding sub-assembly LH as shown in the illustration.
Press the quarter outside moulding sub-assembly LH firmly to install it.
| *a | Double-sided Tape | - | - |
|
Install in this Direction | - | - |
Remove the protective tape.
Install the retainer.
52159
2.INSTALL REAR BUMPER COVER