Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. REPAIR INSTRUCTION
75926C
2.INSTALL NO. 3 BLACK OUT TAPE LH
When installing the No. 3 black out tape LH, heat the rear door panel and No. 3 black out tape LH using a heat light.
| Item | Temperature |
|---|---|
| Rear Door Panel | 40 to 60°C (104 to 140°F) |
| No. 3 Black Out Tape LH | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Refer to the illustration to position a new No. 3 black out tape LH.
| *a | Edge of Curved Surface | - | - |
| Area | Specified Condition | Area | Specified Condition |
|---|---|---|---|
| A | -1.0 to 1.0 mm (-0.0394 to 0.0394 in.) | B | 3.0 mm (0.118 in.) |
| C | 0 to 2.0 mm (0 to 0.0787 in.) | - | - |
Remove the release paper from the No. 3 black out tape LH.
After installing the No. 3 black out tape LH, remove the unnecessary part above the perforation.
75924C
3.INSTALL NO. 2 BLACK OUT TAPE LH
When installing the No. 2 black out tape LH, heat the rear door panel and No. 2 black out tape LH using a heat light.
| Item | Temperature |
|---|---|
| Rear Door Panel | 40 to 60°C (104 to 140°F) |
| No. 2 Black Out Tape LH | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Refer to the illustration to position a new No. 2 black out tape LH.
| *a | Edge of Curved Surface | - | - |
| Area | Specified Condition | Area | Specified Condition |
|---|---|---|---|
| A | -1.0 to 1.0 mm (-0.0394 to 0.0394 in.) | B | 3.0 to 5.0 mm (0.118 to 0.197 in.) |
| C | 3.0 mm (0.118 in.) | D | 0 to 2.0 mm (0 to 0.0787 in.) |
Remove the release paper from the No. 2 black out tape LH.
After installing the No. 2 black out tape LH, remove the unnecessary part above the perforation.
67872
4.INSTALL REAR DOOR WEATHERSTRIP LH
68640A
5.INSTALL REAR DOOR CHECK ASSEMBLY LH
75740
6.INSTALL REAR DOOR BELT MOULDING ASSEMBLY LH
7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION