Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
73370C
1.INSTALL REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH
| *a | Bolt A |
| *b | Bolt B |
Attach the 2 guides and temporarily install the retractor of the rear No. 1 seat outer belt assembly LH with the 2 bolts.
Tighten the 2 bolts in the order shown in the illustration.
Connect the rear No. 1 seat outer belt assembly LH with the bolt.
73178B
2.INSTALL SEAT BELT ANCHOR COVER CAP
62512
3.INSTALL QUARTER INSIDE TRIM BOARD LH
73560
4.INSTALL REAR NO. 2 SEAT OUTER BELT ASSEMBLY LH (for Floor Anchor)
Connect the floor anchor of the rear No. 2 seat outer belt assembly LH with the bolt.
73370C
5.INSTALL REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH (for Floor Anchor)
Connect the floor anchor of the rear No. 1 seat outer belt assembly LH with the bolt.
73233B
6.INSTALL REAR NO. 2 SEAT OUTER LAP BELT ANCHOR COVER
73233A
7.INSTALL REAR NO. 1 SEAT OUTER LAP BELT ANCHOR COVER
67935
8.INSTALL BACK DOOR SCUFF PLATE
67918E
9.INSTALL REAR DOOR SCUFF PLATE LH