Home › Vehicle Interior › SEAT BELT › REAR CENTER SEAT OUTER BELT ASSEMBLY
RM33K0E _58 Vehicle Interior _043554 SEAT BELT _0229929 REAR CENTER SEAT OUTER BELT ASSEMBLY A

SEAT BELT  REAR CENTER SEAT OUTER BELT ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 73310D 1.INSTALL REAR CENTER SEAT 3 POINT TYPE BELT ASSEMBLY

a.
B409142C01
1.115,0.417 1.302,0.615 0.188,0.198 10 true *a 0.958,1.74 1.208,1.906 0.25,0.167 10 true *b 0.948,0.427 1.104,0.625 0.156,0.198 10 true 1 0.771,1.729 0.927,1.927 0.156,0.198 10 true 2
*a Bolt A
*b Bolt B


Attach the 2 guides and temporarily install the rear center seat 3 point type belt assembly with the 2 bolts.


b.

Tighten the 2 bolts in the order shown in the illustration.

Torque:
for Bolt A : 12.5 N*m (127 kgf*cm, 9 ft.*lbf)
for Bolt B : 42 N*m (428 kgf*cm, 31 ft.*lbf)


c.
B409140

Attach the guide and install the through anchor of the rear center seat 3 point type belt assembly.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)


d.

Check that the rear center seat 3 point type belt assembly is not twisted.


Hide 73345 2.INSTALL REAR CENTER SEAT SHOULDER BELT GUIDE

a.
B409141C01
2.135,0.708 1.427,0.615 true 2.219,0.646 2.531,0.844 0.313,0.198 10 true *a 0.51,0.5 0.823,0.698 0.313,0.198 10 true *b 2.51,3.719 2.719,3.917 0.208,0.198 10 true 1 1.792,3.271 2,3.479 0.208,0.208 10 true 2 0.927,3.896 1.083,4.094 0.156,0.198 10 true 3 0.979,3.396 1.135,3.594 0.156,0.198 10 true 4
*a Seat Belt
*b Back of Rear Center Seat Shoulder Guide


Attach the guide and temporarily install the rear center seat shoulder guide with the 4 bolts.

HINT:

Install the rear center seat shoulder belt guide so that the seat belt passes between it and the vehicle as shown in the illustration.



b.

Tighten the 4 bolts in the order shown in the illustration.

Torque:
8.5 N*m (87 kgf*cm, 75 in.*lbf)


Hide 62180A 3.INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH (w/ Curtain Shield Airbag)

Hide 63310 4.INSTALL ROOF HEADLINING ASSEMBLY

Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION