Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
85720G
1.INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
Apply MP grease to the sliding and rotating areas of the regulator motor.
w/ Jam Protection Function:
Using a T25 "TORX" socket wrench, install the power window regulator motor assembly LH with the 3 screws.
A new power window regulator motor assembly LH uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.
w/o Jam Protection Function:
Using a T25 "TORX" socket wrench, install the power window regulator motor assembly LH with the 3 screws.
A new power window regulator motor assembly LH uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.
69804
2.INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH
68104
3.INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH
67408E
4.INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH
68152C
5.INSTALL REAR DOOR GLASS RUN LH
67842E
6.INSTALL REAR DOOR SERVICE HOLE COVER LH
67604
7.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
69284D
8.INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH
9.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
74260
10.INSTALL REAR ARMREST ASSEMBLY LH
67674A
11.INSTALL REAR DOOR FRAME GARNISH LH
12.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION