The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the power window regulator motor disassembly/reassembly are shown below.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
Fully open the rear door glass sub-assembly LH before proceeding with work.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
67674A
3.REMOVE REAR DOOR FRAME GARNISH LH
74260
4.REMOVE REAR ARMREST ASSEMBLY LH
5.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
69284D
6.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH
67604
7.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
67842E
8.REMOVE REAR DOOR SERVICE HOLE COVER LH
68152C
9.REMOVE REAR DOOR GLASS RUN LH
67408E
10.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH
68104
11.REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH
69804
12.REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH
85720G
13.REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
w/ Jam Protection Function:
Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor assembly LH.
w/o Jam Protection Function:
Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor assembly LH.