| *a | Object Exceeding Weight Limit of Transmission Jack |
Be sure to perform this procedure with several people as the rear differential carrier assembly is very heavy.
Be sure to follow the procedure described in the repair manual, or the transmission jack may suddenly drop or a part may fall.
The following procedures are for BD22 (w/ Differential Lock).
1.REMOVE REAR WHEEL
37110F
2.REMOVE REAR PROPELLER SHAFT ASSEMBLY
3.DRAIN DIFFERENTIAL OIL
4.REMOVE REAR AXLE SHAFT WITH BACKING PLATE LH
for Disc Brake
Click hereDrivetrain>AXLE AND DIFFERENTIAL>REAR AXLE SHAFT(for Rear Disc Brake)>REMOVAL
for Drum Brake
Click hereDrivetrain>AXLE AND DIFFERENTIAL>REAR AXLE SHAFT(for Rear Drum Brake)>REMOVAL
5.REMOVE REAR AXLE SHAFT WITH BACKING PLATE RH
Use the same procedure described for the LH side.
41171
6.REMOVE REAR DIFFERENTIAL PROTECTOR
41110
7.REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY
Disconnect the 2 connectors.
Remove the 10 nuts, 10 washers and rear differential carrier assembly.
Be careful not to damage the contact surface.
The rear differential carrier assembly is a heavy component. Make sure that it is supported securely.
Securely support the rear differential carrier assembly while performing this step to avoid excessively tilting or dropping the rear differential carrier assembly.
The remaining oil may leak out when removing the rear differential carrier assembly.
Do not damage the installation surface when removing the rear differential carrier assembly.
Remove the bolts with the rear differential carrier assembly secured.
42181
8.REMOVE REAR DIFFERENTIAL CARRIER GASKET