Home › Engine / Hybrid System › 2TR-FE INTAKE / EXHAUST › EXHAUST PIPE
RM33K0E _51 Engine / Hybrid System _043522 2TR-FE INTAKE / EXHAUST _0232457 EXHAUST PIPE A

2TR-FE INTAKE / EXHAUST  EXHAUST PIPE  INSTALLATION  


PROCEDURE

Hide 17410 1.INSTALL FRONT EXHAUST PIPE ASSEMBLY

a.
A107610

Using a vernier caliper, measure the free length of the compression spring.

Minimum free length:

40 mm (1.57 in.)


If the free length is less than the minimum, replace the compression spring.


b.

Using a wire brush, remove any foreign matter from the gasket installation surface.


c.
A076194C38
2.031,1.583 1.594,1.885 1.594,1.885 1.479,1.885 true 2.438,0.979 3.042,0.979 true 1.271,1.781 1.49,1.958 0.219,0.177 10 false *1 3.104,0.875 3.323,1.052 0.219,0.177 10 false *a
*1 Gasket
*a Wooden Block


Using a plastic-faced hammer and wooden block, tap on a new gasket until its surface is flush with the exhaust manifold.

NOTICE:
·

Be sure to install the gasket so that it faces the correct direction.

·

Do not reuse the gasket.

·

Do not damage the gasket.

·

When connecting the front exhaust pipe assembly, do not push in the gasket with the front exhaust pipe assembly.




d.

Install the front exhaust pipe assembly to the No. 1 exhaust pipe support.


e.

Connect the front exhaust pipe assembly to the exhaust manifold with the 2 compression springs and 2 bolts. Alternately tighten the bolts in several passes.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)


Hide 17420 4.INSTALL CENTER EXHAUST PIPE ASSEMBLY

a.

Install the center exhaust pipe assembly to the 3 No. 1 exhaust pipe supports.


b.

Install a new gasket and the center exhaust pipe assembly to the front exhaust pipe assembly with the 2 bolts and 2 new nuts. Alternately tighten the bolts in several passes.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)

NOTICE:

Do not reuse the gasket.



Hide 17430 5.INSTALL TAIL EXHAUST PIPE ASSEMBLY

a.

Install the tail exhaust pipe assembly to the No. 2 exhaust pipe support.


b.

Install a new gasket and the tail exhaust pipe assembly to the center exhaust pipe assembly with the 2 bolts and 2 new nuts. Alternately tighten the bolts in several passes.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)

NOTICE:

Do not reuse the gasket.



Hide 7.INSPECT FOR EXHAUST GAS LEAK

If gas is leaking, tighten the areas necessary to stop the leak. Replace damaged parts as necessary.

HINT:

If an exhaust gas leak has been repaired, perform an inspection following the repair.

Click hereEngine / Hybrid System>2TR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION