Home › Engine / Hybrid System › 2TR-FE INTAKE / EXHAUST › EXHAUST PIPE
RM33K0E _51 Engine / Hybrid System _043522 2TR-FE INTAKE / EXHAUST _0232457 EXHAUST PIPE A

2TR-FE INTAKE / EXHAUST  EXHAUST PIPE  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the air fuel ratio sensor, front exhaust pipe assembly, center exhaust pipe assembly and tail exhaust pipe assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
·

Replacement of air fuel ratio sensor

·

Gas leaks from exhaust system


Inspection After Repair Poor idle, engine start, etc. (Click here)

CAUTION:
·
A350542

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.

·

Wear protective gloves when removing the exhaust pipe assembly.

·

The exhaust pipe assembly is extremely hot immediately after the engine has stopped.

·

Confirm that the exhaust pipe assembly has cooled down before removing it.



PROCEDURE

Hide 53882F 1.REMOVE FRONT FENDER SEAL RH

Hide 17430 2.REMOVE TAIL EXHAUST PIPE ASSEMBLY

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


a.

Remove the 2 bolts and 2 nuts.


b.

Disconnect the No. 2 exhaust pipe support and remove the tail exhaust pipe assembly.


c.

Remove the gasket from the center exhaust pipe assembly.


Hide 17420 3.REMOVE CENTER EXHAUST PIPE ASSEMBLY

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


a.

Remove the 2 bolts and 2 nuts.


b.

Disconnect the 3 No. 1 exhaust pipe supports and remove the center exhaust pipe assembly and gasket.


Hide 89467B 4.REMOVE AIR FUEL RATIO SENSOR

Hide 17410 6.REMOVE FRONT EXHAUST PIPE ASSEMBLY

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


a.

Remove the 2 bolts and 2 compression springs.


b.

Disconnect the No. 1 exhaust pipe support and remove the front exhaust pipe assembly.


c.

Remove the gasket from the exhaust manifold.