The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the ECM removal/installation are shown below.
55550
1.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
89661
2.REMOVE ECM
w/ Differential Lock:
Disconnect the 2 connectors from the 4 wheel drive control ECU.
Disconnect the 4 connectors from the ECM.
Detach the 2 clamps.
Remove the bolt, 2 nuts and ECM.
89533
3.REMOVE 4 WHEEL DRIVE CONTROL ECU (w/ Differential Lock)
89667A
4.REMOVE NO. 1 ECM BRACKET
Remove the 2 screws and No. 1 ECM bracket.
89668A
5.REMOVE NO. 2 ECM BRACKET
Remove the 2 screws and No. 2 ECM bracket.