Home › Engine / Hybrid System › 2TR-FBE ENGINE CONTROL › KNOCK SENSOR › from 2016.07
RM33K0E _51 Engine / Hybrid System _054512 2TR-FBE ENGINE CONTROL _0269977 KNOCK SENSOR A

2TR-FBE ENGINE CONTROL  KNOCK SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the knock sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Replacement of knock sensor Inspection After Repair Poor idle, engine start, etc. (Click here)

PROCEDURE

Hide 89615 2.REMOVE KNOCK SENSOR

a.

Disconnect the knock sensor connector.


b.
A345930

Remove the bolt and knock sensor.