Home › Engine / Hybrid System › 2TR-FBE INTAKE / EXHAUST › INTAKE MANIFOLD › from 2016.07
RM33K0E _51 Engine / Hybrid System _054516 2TR-FBE INTAKE / EXHAUST _0267063 INTAKE MANIFOLD A

2TR-FBE INTAKE / EXHAUST  INTAKE MANIFOLD  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the intake manifold removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
·

Replacement of throttle body with motor assembly

·

Cleaning the deposits from the throttle body with motor assembly


Inspection after repair Poor idle, engine start, etc. (Click here)

PROCEDURE

Hide 22030 1.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY

Hide 53882F 2.REMOVE FRONT FENDER SEAL LH

Hide 17111 4.REMOVE INTAKE MANIFOLD

a.
A383807

Detach the 3 wire harness clamps from the wire harness clamp bracket.


b.
A383809

Detach the No. 1 fuel hose from the intake manifold.


c.
A385856

Detach the 2 wire harness clamps and disconnect the No. 1 glow plug connector from the intake manifold.


d.
A385857

Detach the wire harness clamp and disconnect the No. 2 glow plug connector from the intake manifold.


e.
A383810

Remove the bolt and disconnect the heater water pipe sub-assembly from the intake manifold.


f.
A384242

Detach the No. 2 water by-pass hose from the intake manifold.


g.

Slide the clip and disconnect the No. 3 PCV hose from the intake manifold.


h.
A384243

Slide the clip and disconnect the union to connector tube hose from the intake manifold.


i.

Slide the clip and remove the purge line hose from the intake manifold.


j.
A384244

Remove the 2 No. 2 intake manifold insulators from the intake manifold.


k.
A384245

Remove the 5 bolts, 2 nuts and intake manifold.


l.

Remove the gasket from the intake manifold.


m.
A385855

Remove the 3 bolts and 3 wire harness clamp brackets from the intake manifold.


n.

Remove the intake manifold insulator from the intake manifold.