The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the heated oxygen sensor removal/installation are shown below.
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
37140
1.REMOVE FRONT PROPELLER SHAFT ASSEMBLY (for 4WD)
89465
2.REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)
Disconnect the connector.
Detach the 2 clamps.
Using SST, remove the heated oxygen sensor from the front exhaust pipe.
Do not damage the heated oxygen sensor.
89465A
3.REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)
Disconnect the connector.
Detach the 2 clamps.
Using SST, remove the heated oxygen sensor from the front exhaust pipe.
Do not damage the heated oxygen sensor.