Home › Engine / Hybrid System › 1GR-FE FUEL › FUEL PRESSURE REGULATOR
RM3250E _51 Engine / Hybrid System _037983 1GR-FE FUEL _0177660 FUEL PRESSURE REGULATOR A

1GR-FE FUEL  FUEL PRESSURE REGULATOR  REMOVAL  


PROCEDURE

Hide 1.DISCHARGE FUEL SYSTEM PRESSURE

Hide 2. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 17129 4.REMOVE INTAKE AIR SURGE TANK

Hide 23802B 5.DISCONNECT NO. 2 FUEL PIPE SUB-ASSEMBLY

Hide 23280 6.REMOVE FUEL PRESSURE REGULATOR ASSEMBLY

a.
A344537

Remove the 2 bolts and fuel pressure regulator assembly from the fuel delivery pipe sub-assembly.


b.

Remove the O-ring from the fuel pressure regulator assembly.


c.

Remove the vacuum hose from the fuel pressure regulator assembly.