The ECM turns on the cruise control indicator light by sending indicator output demand signals to the combination meter assembly using CAN communication.
w/ Multi-information Display:
The cruise control indicator light illuminates when the cruise control system has been turned on using the cruise control main switch (ON/OFF). If a malfunction is detected, the cruise control indicator light goes off and a warning message is displayed.
w/o Multi-information Display:
The cruise control indicator light in the combination meter assembly changes to yellow when a malfunction occurs during cruise control driving.
The cruise control indicator light circuit uses CAN communication. If the cruise control indicator light is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.
When replacing the combination meter assembly, make sure to replace it with a new one.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
According to the display on the GTS, perform the Active Test.
w/ Multi-information Display (for TFT Display Type):
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Meter Display 1 | Multi-information display | OFF or All | - |
| Tester Display |
|---|
| Meter Display 1 |
The multi-information display in the combination meter assembly turns off or completely on according to the GTS operation
w/ Multi-information Display (for Dot Display Type):
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Indicat. Lamp Cruise | Cruise indicator light (Green) | OFF or ON | - |
| Tester Display |
|---|
| Indicat. Lamp Cruise |
Cruise control indicator light turns ON/OFF
w/o Multi-information Display:
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Indicat. Lamp Cruise | Cruise indicator light (Green) | OFF or ON | - |
| Cruise Indicator | Cruise indicator light (Yellow) | OFF or ON | - |
| Tester Display |
|---|
| Indicat. Lamp Cruise |
Cruise control indicator light turns ON/OFF
| Result | Proceed to |
|---|---|
| OK | A |
| NG | B |
A
B
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Enter the following menus: Powertrain / Cruise Control / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| CCS Indicator M-CPU | Cruise control indicator light signal (Main-CPU) | ON or OFF | ON: Cruise control indicator light turns on
OFF: Cruise control indicator light turns off |
- |
| Tester Display |
|---|
| CCS Indicator M-CPU |
| Result | Proceed to |
|---|---|
| The indicator operates normally according to the on and off operations | A |
| The GTS screen display changes from off to on, but the cruise control indicator light in the combination meter assembly does not illuminate | B |
| The cruise control indicator light in the combination meter assembly does not illuminate and the GTS screen display does not change from off | C |
A
B
C
for 1GR-FE: Click hereEngine / Hybrid System>1GR-FE ENGINE CONTROL>ECM>REMOVAL
for 2TR-FE: Click hereEngine / Hybrid System>2TR-FE ENGINE CONTROL>ECM>REMOVAL
for 1GD-FTV: Click hereEngine / Hybrid System>1GD-FTV ENGINE CONTROL>ECM>REMOVAL
for 2GD-FTV: Click hereEngine / Hybrid System>2GD-FTV ENGINE CONTROL>ECM>REMOVAL
for 1KD-FTV: Click hereEngine / Hybrid System>1KD-FTV ENGINE CONTROL>ECM>REMOVAL