Home › Engine / Hybrid System › 1GD-FTV ENGINE CONTROL › ECM
RM3250E _51 Engine / Hybrid System _037972 1GD-FTV ENGINE CONTROL _0187830 ECM A

1GD-FTV ENGINE CONTROL  ECM  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the ECM removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Replacement of ECM
·

Learning values save

·

Learning values write

·

Vehicle Identification Number (VIN) registration


·

Engine starting

·

DTC P0630 is output


(Click here)
w/ DPF:(Click here)

Performing iMT installation information reset


·

iMT system

·

DTCs are output


for RC61:(Click here)
for RC61F:(Click here)
Code registration (Immobiliser system) Engine start function See the Service Bulletin for the registration method.

PROCEDURE

Hide 55607 1.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Cover)

Hide 55550 2.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

Hide 89661 3.REMOVE ECM

A349891C01
0.094,0.073 0.344,0.26 0.25,0.188 10 true *A 0.094,2.479 0.313,2.646 0.219,0.167 10 true *B
*A for LHD
*B for RHD


a.

for LHD:

Detach the 2 clamps.


b.

for RHD:

Detach the 3 clamps.


c.

for 4WD:

i.

Disconnect the 2 4 wheel drive control ECU connectors and 6 ECM connectors.


ii.

Remove the bolt, 2 nuts and ECM with the 4 wheel drive control ECU.



d.

for 2WD and Pre-Runner:

i.

Disconnect the 6 ECM connectors.


ii.

Remove the bolt, 2 nuts and ECM.



Hide 89533 4.REMOVE 4 WHEEL DRIVE CONTROL ECU (for 4WD)

Hide 89667A 5.REMOVE NO. 1 ECM BRACKET

a.
A349892C01
0.052,0.063 0.365,0.219 0.313,0.156 10 false *A 0.083,2.479 0.396,2.635 0.313,0.156 10 false *B
*A for LHD
*B for RHD


Remove the 2 screws and No. 1 ECM bracket.


Hide 89668A 6.REMOVE NO. 2 ECM BRACKET

a.
A349893C01
0.073,0.073 0.385,0.229 0.313,0.156 10 false *A 0.115,2.417 0.427,2.573 0.313,0.156 10 false *B
*A for LHD
*B for RHD


Remove the 2 screws and No. 2 ECM bracket.