Home › Engine / Hybrid System › 1GR-FE INTAKE / EXHAUST › EXHAUST PIPE
RM3250E _51 Engine / Hybrid System _037985 1GR-FE INTAKE / EXHAUST _0179730 EXHAUST PIPE A

1GR-FE INTAKE / EXHAUST  EXHAUST PIPE  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front exhaust pipe assembly, front No. 2 exhaust pipe assembly and tail exhaust pipe assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Gas leaks from exhaust system Inspection After Repair Poor idle, engine start, etc. (Click here)

CAUTION:
·
A358533

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.

·

Wear protective gloves when removing the exhaust pipe.

·

The exhaust pipe is extremely hot immediately after the engine has stopped.

·

Confirm that the exhaust pipe has cooled down before removing it.



PROCEDURE

Hide 17430 1.REMOVE TAIL EXHAUST PIPE ASSEMBLY

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


a.

Remove the 2 bolts and 2 compression springs.


b.

Disconnect the 3 No. 1 exhaust pipe supports and No. 2 exhaust pipe support and remove the tail exhaust pipe assembly.


c.

Remove the gasket.


Hide 17450B 2.REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


a.
A356049

Disconnect the heated oxygen sensor connector.


b.

Detach the 2 clamps.


c.

Remove the 2 bolts and 4 nuts.


d.

Disconnect the No. 1 exhaust pipe support and remove the front No. 2 exhaust pipe assembly.


e.

Remove the 2 gaskets.


Hide 89465 3.REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)

Hide 89465 4.REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)

Hide 17410 5.REMOVE FRONT EXHAUST PIPE ASSEMBLY

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


a.

Remove the 2 nuts.


b.

Disconnect the No. 1 exhaust pipe support and remove the front exhaust pipe assembly.


c.

Remove the gasket.