This DTC is stored when a malfunction occurs in the digital audio broadcasting antenna assembly which is connected to the radio and display receiver assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B157D | DAB Tuner Antenna Disconnected | The windshild glass (window glass antenna wire) is not connected | ·
Antenna cord sub-assembly ·
No. 2 antenna cord sub-assembly ·
Windshield glass (window glass antenna wire) ·
Radio and display receiver assembly |
When replacing the radio and display receiver assembly, it is necessary to perform the vehicle contract setting for Connected Services (w/ Connected Services Function).
Clear the DTCs.
Recheck for DTCs and check that no DTCs are output.
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check if the DAB radio antenna cable is securely connected to the radio and display receiver assembly.
DAB radio antenna cable is securely connected.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Inspect the windshield glass (window glass antenna wire).
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>WINDOW GLASS ANTENNA WIRE>ON-VEHICLE INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to Radio and Display Receiver Assembly) |
| *b | Front view of wire harness connector
(to No. 2 Antenna Cord Sub-assembly) |
Remove the antenna connector from the radio and display receiver assembly.
Remove the antenna connector from the No. 2 antenna cord sub-assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| DB-1 - 1 | Always | Below 1 Ω |
| DB-1a - 1a | Always | Below 1 Ω |
| DB-1 - Body ground | Always | 10 kΩ or higher |
| DB-1a - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to Antenna Cord Sub-assembly) |
| *b | Front view of wire harness connector
(to Digital Audio Broadcasting Antenna Assembly) |
Remove the antenna connector from the antenna cord sub-assembly.
Remove the antenna connector from the digital audio broadcasting antenna assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 1 | Always | Below 1 Ω |
| 1a - 1a | Always | Below 1 Ω |
| 1 - Body ground | Always | 10 kΩ or higher |
| 1a - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG