Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
55302A
3.REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY
86101
4.REMOVE ANTENNA CORD SUB-ASSEMBLY (for RHD)
w/o Navigation System:
Disconnect the connector.
Detach the clamps shown in the illustration.
Remove the bolt and antenna cord sub-assembly.
w/ Navigation System:
Disconnect the connector.
Detach the clamps shown in the illustration.
Remove the bolt and antenna cord sub-assembly.
86101
5.REMOVE ANTENNA CORD SUB-ASSEMBLY (for LHD)
w/o Navigation System:
Disconnect the connector.
Detach the clamps shown in the illustration.
Remove the bolt and antenna cord sub-assembly.
w/ Navigation System:
Disconnect the connector.
Detach the clamps shown in the illustration.
Remove the bolt and antenna cord sub-assembly.
63310
6.REMOVE ROOF HEADLINING ASSEMBLY
for Single Cab:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Single Cab)>REMOVAL
for Smart Cab:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Smart Cab)>REMOVAL
for Double Cab:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Double Cab)>REMOVAL
86101J
7.REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY
w/o Digital Audio Broadcasting Antenna
Disconnect the connectors.
Detach the clamps and remove the No. 2 antenna cord sub-assembly.
w/ Digital Audio Broadcasting Antenna
Disconnect the connectors and remove the bolt.
Detach the clamps, guide and remove the No. 2 antenna cord sub-assembly.