48220
1.INSTALL REAR SPRING ASSEMBLY LH
Install the rear spring assembly LH to the vehicle body.
48210A
2.INSTALL REAR UPPER SPRING SHACKLE BUSH
Install 2 new rear upper spring shackle bushes to the vehicle frame.
3.INSTALL NO. 2 SPRING SHACKLE SUB-ASSEMBLY
Install the No. 2 rear spring shackle sub-assembly to the rear spring assembly LH and vehicle body.
4.TEMPORARILY INSTALL SPRING SHACKLE INNER PLATE
| *a | Bottom of Vehicle |
Temporarily install the spring shackle inner plate to the No. 2 rear spring shackle sub-assembly with the 2 washers and 2 nuts shown in the illustration.
After stabilizing the suspension, tighten the nuts.
5.TEMPORARILY INSTALL PIN BOLT (except Single Cab)
Temporarily install the pin bolt with the washer and nut.
After stabilizing the suspension, tighten the nut.
48409A
6.TEMPORARILY INSTALL REAR SPRING BRACKET PIN SUB-ASSEMBLY (for Single Cab)
Temporarily install the rear spring bracket pin sub-assembly with the washer and nut.
Temporarily install the set bolt.
After stabilizing the suspension, tighten the nut.
48046A
7.TEMPORARILY INSTALL REAR SPRING U BOLT
Temporarily install the 2 rear spring U bolts and U bolt seat with the 4 washers and 4 nuts.
When tightening the U bolts, tighten the nuts in diagonal pairs.
48341
8.INSTALL REAR SPRING BUMPER
Install the rear spring bumper with the 2 bolts.
48540
9.INSTALL REAR SHOCK ABSORBER ASSEMBLY LH
46430
10.CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY
Connect the No. 3 parking brake cable assembly with the bolt.
11.STABILIZE SUSPENSION
12.TIGHTEN SPRING SHACKLE INNER PLATE
Tighten the 2 nuts.
13.TIGHTEN PIN BOLT (except Single Cab)
Tighten the pin nut.
48409A
14.TIGHTEN REAR SPRING BRACKET PIN SUB-ASSEMBLY (for Single Cab)
Tighten the pin nut.
Tighten the set bolt.
48047
15.TIGHTEN SPRING U BOLT SEAT SUB-ASSEMBLY LH
Tighten the 4 nuts.
16.INSTALL REAR WHEEL