Home › Suspension › REAR SUSPENSION › REAR LEAF SPRING(for 4WD and Pre-Runner)
RM3250E _53 Suspension _038042 REAR SUSPENSION _0182547 REAR LEAF SPRING(for 4WD and Pre-Runner) A

REAR SUSPENSION  REAR LEAF SPRING(for 4WD and Pre-Runner)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear leaf spring removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced:
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
w/ Automatic Headlight Beam Level Control System:

Rear height control sensor sub-assembly LH


Headlight leveling ECU assembly initialization Headlight leveling function (Click here)


HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 89408C 2.REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ Automatic Headlight Beam Level Control System)

Hide 46430 3.DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY

C322872

a.

Remove the bolt and disconnect the No. 3 parking brake cable assembly from the rear leaf spring assembly LH.


Hide 48540 4.REMOVE REAR SHOCK ABSORBER ASSEMBLY LH

Hide 48046A 5.REMOVE REAR SPRING U BOLT

C322873

a.

Remove the 4 nuts, 4 washers, 2 rear spring U bolts, rear spring bumper and spring U bolt seat sub-assembly.


Hide 6.REMOVE REAR LEAF SPRING PIN BOLT

C322874

a.

Remove the nut, washer and rear leaf spring pin bolt.


Hide 7.REMOVE SPRING SHACKLE INNER PLATE

C322875

a.

Remove the 2 nuts, 2 washers and spring shackle inner plate.


Hide 8.REMOVE NO. 2 REAR SPRING SHACKLE SUB-ASSEMBLY

a.

Using a screwdriver, remove the No. 2 rear spring shackle sub-assembly.

HINT:

Tape the screwdriver tip before use.



Hide 48210A 9.REMOVE REAR UPPER SPRING SHACKLE BUSH

a.

Using a screwdriver, remove the 2 rear upper spring shackle bushes from the vehicle frame.

HINT:

Tape the screwdriver tip before use.



Hide 48220 10.REMOVE REAR LEAF SPRING ASSEMBLY LH

a.

Remove the rear leaf spring assembly LH from the vehicle body.