Home › Engine / Hybrid System › 1TR-FE FUEL › FUEL PRESSURE REGULATOR
RM3250E _51 Engine / Hybrid System _037999 1TR-FE FUEL _0182610 FUEL PRESSURE REGULATOR A

1TR-FE FUEL  FUEL PRESSURE REGULATOR  REMOVAL  


PROCEDURE

Hide 1.DISCHARGE FUEL SYSTEM PRESSURE

Hide 2. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 17861 4.REMOVE INTAKE AIR CONNECTOR

Hide 23273H 5.DISCONNECT NO. 2 FUEL HOSE

Hide 23280 6.REMOVE FUEL PRESSURE REGULATOR ASSEMBLY

a.
A346786

Disconnect the purge VSV connector.


b.

Disconnect the throttle body connector.


c.

Detach the wire harness clamp.


d.
A346787

Remove the vacuum hose.


e.

Remove the 3 bolts and fuel pressure regulator assembly.


f.

Remove the O-ring from the fuel pressure regulator assembly.