Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
69220
1.INSTALL FRONT DOOR OUTSIDE HANDLE ASSEMBLY LH
Apply MP grease to the sliding area of the front door outside handle assembly LH.
|
Install in this Direction |
Install the front door outside handle assembly LH by moving it in the direction indicated by the arrow shown in the illustration.
Attach the claw of the connector to connect the connector.
|
Install in this Direction |
Attach the claws of the connector cover to connect the connector cover.
69217D
2.INSTALL FRONT DOOR OUTSIDE HANDLE COVER
Apply MP grease to the sliding parts of the lock cylinder.
Install the front door outside handle cover with lock cylinder.
| *1 | Hole Plug |
|
Install in this Direction |
Using a T30 "TORX" socket wrench, tighten the screw.
Install the hole plug.
67832
3.INSTALL FRONT DOOR SERVICE HOLE COVER LH
67602
4.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
74220
5.INSTALL FRONT ARMREST ASSEMBLY LH
6.INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL
69284C
7.INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH
67492A
8.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH