Home › Drivetrain › AXLE AND DIFFERENTIAL › DIFFERENTIAL SYSTEM(w/ Differential Lock)
RM3250E _52 Drivetrain _038039 AXLE AND DIFFERENTIAL _0184154 DIFFERENTIAL SYSTEM(w/ Differential Lock) C

AXLE AND DIFFERENTIAL  DIFFERENTIAL SYSTEM(w/ Differential Lock)  U0416  Invalid Data Received From Vehicle Dynamics Control Module  


DESCRIPTION

This DTC is detected if a wheel speed malfunction signal is sent from the skid control ECU (brake actuator assembly).

DTC No. Detection Item DTC Detection Condition Trouble Area
U0416 Invalid Data Received From Vehicle Dynamics Control Module
·

Diagnosis Condition: Ignition switch turned to ON (3 seconds elapse after ignition switch is turned to ON)

·

Malfunction Status: Wheel speed sensor malfunction signals from skid control ECU are received

·

Malfunction Time: 0.06 seconds or more (malfunction signal received 1 or more times)

·

Other: 1 trip detection logic


·

CAN communication system

·

Anti-lock brake system (w/o VSC)

·

Vehicle stability control system (w/ VSC)



PROCEDURE

1.RECONFIRM DTC
a.

Clear the DTCs.

Click hereDrivetrain>AXLE AND DIFFERENTIAL>DIFFERENTIAL SYSTEM(w/ Differential Lock)>DTC CHECK / CLEAR

Powertrain > Four Wheel Drive > Clear DTCs
50002 363

b.

Check if the same DTCs are output.

Click hereDrivetrain>AXLE AND DIFFERENTIAL>DIFFERENTIAL SYSTEM(w/ Differential Lock)>DTC CHECK / CLEAR

Powertrain > Four Wheel Drive > Trouble Codes
50001 363

Result:
Result Proceed to
DTC U0122 and U0416 are output A
Only DTC U0416 is output B
DTC is not output C



A

B

C