| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B1507 | Open in Turn Signal Circuit | Open in turn signal light circuit. | ·
Harness or connector ·
Side turn signal light assembly*1 ·
Outer rear view mirror assembly*1 ·
Rear combination light socket and wire sub-assembly*2 ·
Combination meter assembly |
| B1508 | Short in Turn Signal / Hazard Flasher Circuit | Short in turn signal light circuit or hazard warning light circuit. | ·
Harness or connector ·
Side turn signal light assembly*1 ·
Outer rear view mirror assembly*1 ·
Rear combination light socket and wire sub-assembly*2 ·
Combination meter assembly |
*1: w/ Outer Rear View Mirror Type Side Turn Signal Light
*2: w/ Deck
When replacing the combination meter assembly, make sure to replace it with a new one.
Inspect the bulbs for circuits related to this system before performing the following procedure.
Clear the DTCs.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DTC CHECK / CLEAR
Recheck for DTCs and check that no DTCs are output.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DTC CHECK / CLEAR
B1507 and B1508 are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Check the illumination of each turn signal light.
| Result | Proceed to |
|---|---|
| LH side turn signal light does not illuminate. | A |
| RH side turn signal light does not illuminate. | B |
A
B
*1: w/ Outer Rear View Mirror Type Side Turn Signal Light
*2: w/ Front Fender Type Side Turn Signal Light
*3: w/o Deck
*4: w/ Deck
Disconnect the G11 combination meter assembly connector.
Disconnect the A30 headlight assembly LH connector.
Disconnect the K3 outer rear view mirror assembly LH connector.*1
Disconnect the A32 side turn signal light assembly LH connector.*2
Disconnect the O2 rear combination light assembly LH*3 or rear combination light socket and wire sub-assembly LH*4 connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G11-8 (LL) - A30-2 (B) | Always | Below 1 Ω |
| G11-8 (LL) - K3-10 (TRNL)*1 | Always | Below 1 Ω |
| G11-8 (LL) - A32-1*2 | Always | Below 1 Ω |
| G11-8 (LL) - O2-1 (B) | Always | Below 1 Ω |
| A30-1 (E) - Body ground | Always | Below 1 Ω |
| K3-6 (GND) - Body ground*1 | Always | Below 1 Ω |
| A32-2 - Body ground*2 | Always | Below 1 Ω |
| O2-3 (E) - Body ground | Always | Below 1 Ω |
| G11-8 (LL) - Body ground | Always | 10 kΩ or higher |
| Result | Proceed to |
|---|---|
| OK (w/ Outer Rear View Mirror Type Side Turn Signal Light) | A |
| OK (w/ Front Fender Type Side Turn Signal Light) | B |
| NG | C |
A
B
C
Remove the outer rear view mirror assembly LH.
Click hereVehicle Exterior>MIRROR (EXT)>OUTER REAR VIEW MIRROR>REMOVAL
Inspect the outer rear view mirror assembly LH.
Click hereVehicle Exterior>MIRROR (EXT)>OUTER REAR VIEW MIRROR>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check the rear combination light type.
| Result | Proceed to |
|---|---|
| w/ Deck | A |
| w/o Deck | B |
A
B
Remove the rear combination light socket and wire sub-assembly LH.
Click hereVehicle Exterior>LIGHTING (EXT)>REAR COMBINATION LIGHT ASSEMBLY>DISASSEMBLY
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A-1 (B) - B-1 | Always | Below 1 Ω |
| A-3 (E) - B-2 | Always | Below 1 Ω |
| A-1 (B) or B-1 - Body ground | Always | 10 kΩ or higher |
| A-3 (E) or B-2 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the side turn signal light assembly LH.
Click hereVehicle Exterior>LIGHTING (EXT)>SIDE TURN SIGNAL LIGHT ASSEMBLY(for Outer Rear View Mirror)>REMOVAL
Inspect the side turn signal light assembly LH.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereVehicle Exterior>LIGHTING (EXT)>SIDE TURN SIGNAL LIGHT ASSEMBLY(for Outer Rear View Mirror)>REMOVAL
*1: w/ Outer Rear View Mirror Type Side Turn Signal Light
*2: w/ Front Fender Type Side Turn Signal Light
*3: w/o Deck
*4: w/ Deck
Disconnect the G11 combination meter assembly connector.
Disconnect the A29 headlight assembly RH connector.
Disconnect the J3 outer rear view mirror assembly RH connector.*1
Disconnect the A31 side turn signal light assembly RH connector.*2
Disconnect the O1 rear combination light assembly RH*3 or rear combination light socket and wire sub-assembly RH*4 connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G11-13 (LR) - A29-2 (B) | Always | Below 1 Ω |
| G11-13 (LR) - J3-10 (TRNR)*1 | Always | Below 1 Ω |
| G11-13 (LR) - A31-1*2 | Always | Below 1 Ω |
| G11-13 (LR) - O1-1 (B) | Always | Below 1 Ω |
| A29-1 (E) - Body ground | Always | Below 1 Ω |
| J3-6 (GND) - Body ground*1 | Always | Below 1 Ω |
| A31-2 - Body ground*2 | Always | Below 1 Ω |
| O1-3 (E) - Body ground | Always | Below 1 Ω |
| G11-13 (LR) - Body ground | Always | 10 kΩ or higher |
| Result | Proceed to |
|---|---|
| OK (w/ Outer Rear View Mirror Type Side Turn Signal Light) | A |
| OK (w/ Front Fender Type Side Turn Signal Light) | B |
| NG | C |
A
B
C
Remove the outer rear view mirror assembly RH.
Click hereVehicle Exterior>MIRROR (EXT)>OUTER REAR VIEW MIRROR>REMOVAL
Inspect the outer rear view mirror assembly RH.
Click hereVehicle Exterior>MIRROR (EXT)>OUTER REAR VIEW MIRROR>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check the rear combination light type.
| Result | Proceed to |
|---|---|
| w/ Deck | A |
| w/o Deck | B |
A
B
Remove the rear combination light socket and wire sub-assembly RH.
Click hereVehicle Exterior>LIGHTING (EXT)>REAR COMBINATION LIGHT ASSEMBLY>DISASSEMBLY
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A-1 (B) - B-1 | Always | Below 1 Ω |
| A-3 (E) - B-2 | Always | Below 1 Ω |
| A-1 (B) or B-1 - Body ground | Always | 10 kΩ or higher |
| A-3 (E) or B-2 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the side turn signal light assembly RH.
Click hereVehicle Exterior>LIGHTING (EXT)>SIDE TURN SIGNAL LIGHT ASSEMBLY(for Outer Rear View Mirror)>REMOVAL
Inspect the side turn signal light assembly RH.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereVehicle Exterior>LIGHTING (EXT)>SIDE TURN SIGNAL LIGHT ASSEMBLY(for Outer Rear View Mirror)>REMOVAL