The air conditioning control assembly communicates with the air conditioning amplifier assembly through the LIN communication system.
If the LIN communication system malfunctions, the air conditioning amplifier assembly does not operate even if the air conditioning control assembly is operated.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | Note |
|---|---|---|---|---|---|
| B14B2 | Lost Communication with Front Panel LIN | Lost communication with the air conditioning control assembly | ·
Harness or connector ·
LIN communication system ·
Air conditioning control assembly ·
Air conditioning amplifier assembly |
Memorized (10 seconds or more) | - |
The air conditioning amplifier assembly stores the DTC of the respective malfunction if it has occurred for the period of time indicated in the parentheses.
Inspect the fuses for circuits related to this system before performing the following procedure.
When the servo motor or air conditioning amplifier assembly is replaced, be sure to perform servo motor initialization.
| *a | Rear view of wire harness connector
(to Air Conditioning Control Assembly) |
Disconnect the air conditioning control assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G32-4 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G32-2 (IG+) - Body ground | Ignition switch off | Below 1 V |
| G32-2 (IG+) - Body ground | Ignition switch ON | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the G32 air conditioning control assembly connector.
Disconnect the G33 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G32-3 (LIN1) - G33-37 (LIN1) | Always | Below 1 Ω |
| G32-3 (LIN1) or G33-37 (LIN1) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the air conditioning control assembly.
When troubleshooting according to the DTC:
Check for DTCs.
DTC B14B2 is not output.
When troubleshooting according to Problem Symptoms Table:
Check that the air conditioning control assembly operates normally.
Since the air conditioning control assembly cannot be inspected while it is removed from the vehicle, replace the air conditioning control assembly with a new or known good one and check that the condition returns to normal.
Air conditioning control assembly operation returns to normal.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (When troubleshooting according to the DTC) | B |
| NG (When troubleshooting according to Problem Symptoms Table) | C |
A
B
C