AIR CONDITIONING AMPLIFIER ASSEMBLY (w/o PTC Heater)
Disconnect the G34 air conditioning amplifier assembly connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| G34-7 (IG+) - Body ground | G - Body ground | Power source (IG) | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V | |||
| G34-11 (GND) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
Reconnect the G34 air conditioning amplifier assembly connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| G34-2 (AC1) - Body ground | GR - Body ground | Idle-up request signal | ·
Engine running ·
Blower switch: LO or higher ·
"A/C" switch: Off |
11 to 14 V |
·
Engine running ·
Blower switch: LO or higher ·
"A/C" switch: On |
Below 1 V | |||
| G34-3 (PSW) - Body ground | L - Body ground | Air conditioner pressure sensor signal | ·
Engine running ·
Refrigerant pressure normal ·
Blower switch: LO or higher ·
"A/C" switch: On |
Below 1 V |
·
Engine running ·
Refrigerant pressure abnormal (below 0.176 MPa [1.8 kgf/cm2, 25.5 psi] or higher than 3.025 MPa [30.9 kgf/cm2, 438.6 psi]) ·
Blower switch: LO or higher ·
"A/C" switch: On |
11 to 14 V | |||
| G34-4 (ACT) - Body ground | LG - Body ground | Magnet clutch on permit signal | ·
Engine running ·
Blower switch: LO or higher ·
"A/C" switch: On (magnet clutch on) |
4.5 to 5.5 V |
·
Engine running ·
Blower switch: LO or higher ·
"A/C" switch: Off or on (magnet clutch off) |
Below 1 V | |||
| G34-5 (SG-2) - Body ground | L - Body ground | Ground for No. 1 cooler thermistor | Always | Below 1 Ω |
| G34-6 (TE) - Body ground | P - Body ground | No. 1 cooler thermistor signal | Evaporator temperature (ambient): 0°C (32°F) | 1.7 to 2.1 V |
| Evaporator temperature (ambient): 15°C (59°F) | 1.0 to 1.3 V | |||
| Evaporator temperature (ambient): 20°C (68°F) | 0.8 to 1.1 V | |||
| Evaporator temperature (ambient): 25°C (77°F) | 0.6 to 0.9 V | |||
| Evaporator temperature (ambient): 30°C (86°F) | 0.5 to 0.8 V | |||
| G34-9 (A/C) - Body ground | B - Body ground | Blower switch signal | ·
Ignition switch ON ·
Blower switch: LO or higher ·
"A/C" switch: On |
Below 1 V |
·
Ignition switch ON ·
Blower switch: LO or higher ·
"A/C" switch: Off |
11 to 14 V | |||
| G34-10 (MGC) - Body ground | V - Body ground | Cooler compressor assembly operation signal | ·
Engine running ·
Blower switch set to LO or higher ·
"A/C" switch: Off or on (magnet clutch off) |
11 to 14 V |
·
Engine running ·
Blower switch set to LO or higher ·
"A/C" switch: On (magnet clutch on) |
Below 1 V |
AIR CONDITIONING AMPLIFIER ASSEMBLY (w/ PTC Heater)
Disconnect the G77 air conditioning amplifier assembly connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| G77-1 (IG+) - Body ground | G - Body ground | Power source (IG) | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V | |||
| G77-23 (GND) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
Reconnect the G77 air conditioning amplifier assembly connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| G77-2 (SWVC) - Body ground*1, *2 | R - Body ground | ·
Heater switch assembly operation signal*1 ·
Idle up switch operation signal*2 |
·
Engine running ·
Heater switch assembly: Off → on*1 ·
Idle up switch: Off → on*2 |
Below 1 V → 11 to 14 V |
| G77-3 (HEAT) - Body ground | G - Body ground | Blower switch signal | ·
Engine running ·
Blower switch: Off |
Below 1 V |
·
Engine running ·
Blower switch: On |
11 to 14 V | |||
| G77-4 (TE) - Body ground | P - Body ground | No. 1 cooler thermistor signal | Evaporator temperature (ambient): 0°C (32°F) | 1.7 to 2.1 V |
| Evaporator temperature (ambient): 15°C (59°F) | 1.0 to 1.3 V | |||
| Evaporator temperature (ambient): 20°C (68°F) | 0.8 to 1.1 V | |||
| Evaporator temperature (ambient): 25°C (77°F) | 0.6 to 0.9 V | |||
| Evaporator temperature (ambient): 30°C (86°F) | 0.5 to 0.8 V | |||
| G77-5 (SG-2) - Body ground | L - Body ground | Ground for No. 1 cooler thermistor | Always | Below 1 Ω |
| G77-6 (VER2) - Body ground*1 | W-B - Body ground | Ground | Always | Below 1 Ω |
| G77-7 (A/C) - Body ground | B - Body ground | Blower switch signal | ·
Ignition switch ON ·
Blower switch: LO or higher ·
"A/C" switch: On |
11 to 14 V |
·
Ignition switch ON ·
Blower switch: LO or higher ·
"A/C" switch: Off |
Below 1 V | |||
| G77-12 (AC1) - Body ground | GR - Body ground | Idle-up request signal | ·
Engine running ·
Blower switch: LO ·
"A/C" switch: Off |
11 to 14 V |
·
Engine running ·
Blower switch: LO ·
"A/C" switch: On |
Below 1 V | |||
| G77-13 (PTC1) - Body ground | L - Body ground | Quick heater assembly operation signal | ·
Engine starts ·
ECO mode switch: Off ·
Temperature settings: MAX HOT ·
Ambient temperature: 10°C (50°F) or lower ·
Engine coolant temperature: 64°C (147°F) or lower ·
Light control switch: Off ·
Blower switch: Off → on (after 10 seconds) |
11 to 14 V → Below 1 V |
| G77-16 (MGC) - Body ground | V - Body ground | Cooler compressor assembly operation signal | ·
Engine running ·
Blower switch: LO or higher ·
"A/C" switch: Off or on (magnet clutch off) |
11 to 14 V |
·
Engine running ·
Blower switch: LO or higher ·
"A/C" switch: On (magnet clutch on) |
Below 1 V | |||
| G77-17 (PSW) - Body ground | L - Body ground | Air conditioner pressure sensor signal | ·
Engine running ·
Refrigerant pressure normal |
Below 1 V |
·
Engine running ·
Refrigerant pressure abnormal (below 0.176 MPa [1.8 kgf/cm2, 25.5 psi] or higher than 3.025 MPa [30.9 kgf/cm2, 438.6 psi]) |
11 to 14 V | |||
| G77-18 (ACT) - Body ground | LG - Body ground | Magnet clutch on permit signal | ·
Engine running ·
Blower switch: LO or higher ·
"A/C" switch: On (magnet clutch on) |
4.5 to 5.5 V |
·
Engine running ·
Blower switch: LO or higher ·
"A/C" switch: Off or on (magnet clutch off) |
Below 1 V | |||
| G77-19 (PTC2) - Body ground | W - Body ground | Quick heater assembly operation signal | ·
Engine starts ·
ECO mode switch: Off ·
Temperature settings: MAX HOT ·
Ambient temperature: 10°C (50°F) or lower ·
Engine coolant temperature: 64°C (147°F) or lower ·
Light control switch: Off ·
Blower switch: Off → on (after 20 seconds) |
11 to 14 V → Below 1 V |
| G77-20 (PTC3) - Body ground | SB - Body ground | Quick heater assembly operation signal | ·
Engine starts ·
ECO mode switch: Off ·
Temperature settings: MAX HOT ·
Ambient temperature: 10°C (50°F) or lower ·
Engine coolant temperature: 64°C (147°F) or lower ·
Light control switch: Off ·
Blower switch: Off → on (after 30 seconds) |
11 to 14 V → Below 1 V |
| G77-23 (GND) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
*1: w/ Viscous Heater
*2: w/ Idle Up Switch
ECM
for 1GD-FTV (w/ DPF):Engine / Hybrid System>1GD-FTV ENGINE CONTROL>ECD SYSTEM(w/ DPF)>TERMINALS OF ECM
for 2GD-FTV (w/ DPF):Engine / Hybrid System>2GD-FTV ENGINE CONTROL>ECD SYSTEM(w/ DPF)>TERMINALS OF ECM