16361A
1.REMOVE FAN AND GENERATOR V BELT
53735B
2.REMOVE FRONT UPPER FENDER APRON SEAL LH
88320
3.DISCONNECT COOLER COMPRESSOR ASSEMBLY
Remove the bolt and disconnect the suction hose sub-assembly from the engine.
Disconnect the cooler compressor connector.
Remove the 2 bolts and 2 nuts.
Using an E8 "TORX" socket wrench, remove the 2 stud bolts and disconnect the cooler compressor assembly.
Support the cooler compressor assembly securely.
It is not necessary to completely remove the cooler compressor assembly. With the hoses connected to the cooler compressor assembly, hang the cooler compressor assembly on the vehicle body with a rope.
88431
4.REMOVE NO. 1 COMPRESSOR MOUNTING BRACKET
11301K
5.REMOVE CRANKSHAFT POSITION SENSOR
Disconnect the crankshaft position sensor connector.
Disconnect the crankshaft position sensor connector from the connector bracket.
Detach the harness clamp.
Remove the bolt and crankshaft position sensor.