Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE FRONT WHEEL
89543
2.DISCONNECT FRONT SPEED SENSOR LH
47750
3.REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY LH
43512
4.REMOVE FRONT DISC
43514C
5.REMOVE FRONT AXLE HUB GREASE CAP LH (for 4WD)
Using a screwdriver and hammer, remove the front axle hub grease cap LH.
Do not damage the front axle hub.
43502H
6.REMOVE FRONT AXLE SHAFT NUT LH (for 4WD)
Remove the cotter pin and lock cap.
Using a 35 mm socket wrench, remove the axle shaft nut LH.
43502C
7.REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH (for 4WD)
Remove the 4 bolts, dust cover and front axle hub sub-assembly LH from the steering knuckle LH.
Remove the O-ring from the front axle hub sub-assembly LH.
43502C
8.REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH (for Pre-Runner)
Remove the 4 bolts, dust cover and front axle hub sub-assembly LH from the steering knuckle LH.
Remove the O-ring from the front axle hub sub-assembly LH.
43502M
9.REMOVE FRONT AXLE HUB INNER BEARING LH (for 4WD)
Fix the front axle hub sub-assembly LH in a soft vise.
Using SST, remove the front axle hub inner bearing LH.
43502M
10.REMOVE FRONT AXLE HUB INNER BEARING LH (for Pre-Runner)
Using SST and a hammer, unstake the adjusting nut.
Using SST, remove the adjusting nut.
Fix the front axle hub in a soft vise.
Using SST, remove the front axle hub inner bearing LH.
43502F
11.REMOVE FRONT AXLE HUB OIL SEAL LH
Using a screwdriver, pry out the front axle hub oil seal LH.
12.REMOVE PLUG (for Pre-Runner)
Using a screwdriver and hammer, remove the plug.