Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE REAR WHEEL
2.REMOVE REAR BRAKE
for 2WD:
Click hereBrake>BRAKE (REAR)>REAR BRAKE(for TMT Made 2WD)>REMOVAL
for 4WD and Pre-Runner:
Click hereBrake>BRAKE (REAR)>REAR BRAKE(for TMT Made 4WD and Pre-Runner)>REMOVAL
89546
3.REMOVE REAR SPEED SENSOR LH (w/ ABS)
for 2WD:
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>REAR SPEED SENSOR>REMOVAL
for 4WD and Pre-Runner:
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>REAR SPEED SENSOR>REMOVAL
4.DISCONNECT PARKING BRAKE CABLE
Remove the 2 bolts and disconnect the parking brake cable.
42312
5.REMOVE REAR AXLE SHAFT WITH BACKING PLATE
Remove the 4 nuts.
Pull out the rear axle shaft with backing plate from the rear axle housing.
42422B
6.REMOVE REAR AXLE BEARING CASE O-RING LH
Remove the rear axle bearing case O-ring LH from the rear axle housing.
42312C
7.REMOVE REAR AXLE SHAFT OIL SEAL LH
Using SST, tap out the rear axle shaft oil seal LH.
Be careful not to damage the rear axle housing hole.