1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
51410
2.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY (for 4WD and Pre-Runner)
3.DRAIN ENGINE COOLANT
for 1TR-FE:
Click hereEngine / Hybrid System>1TR-FE COOLING>COOLANT>REPLACEMENT
for 2TR-FE:
Click hereEngine / Hybrid System>2TR-FE COOLING>COOLANT>REPLACEMENT
16361A
4.REMOVE FAN AND GENERATOR V BELT
for 2TR-FE:
Click hereEngine / Hybrid System>2TR-FE ENGINE MECHANICAL>DRIVE BELT>REMOVAL
for 1TR-FE:
Click hereEngine / Hybrid System>1TR-FE ENGINE MECHANICAL>DRIVE BELT>REMOVAL
5.DISCONNECT VANE PUMP ASSEMBLY
16572
6.REMOVE RADIATOR HOSE OUTLET
for 1TR-FE:
Click hereEngine / Hybrid System>1TR-FE COOLING>RADIATOR>REMOVAL
for 2TR-FE:
Click hereEngine / Hybrid System>2TR-FE COOLING>RADIATOR>REMOVAL
7.REMOVE FRONT WHEEL LH
53737B
8.REMOVE FRONT FENDER APRON SEAL LH
for 4WD, for Pre-Runner:
Remove the 6 clips and front fender apron seal LH.
for 2WD:
Remove the 5 clips and front fender apron seal LH.
88711
9.DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE
| *A | w/o Thermostat |
| *B | w/ Thermostat |
Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose from the compressor assembly with magnet clutch.
Remove the O-ring from the No. 1 cooler refrigerant discharge hose.
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
88704
10.DISCONNECT SUCTION HOSE SUB-ASSEMBLY
| *A | w/o Thermostat |
| *B | w/ Thermostat |
Remove the bolt and disconnect the suction hose sub-assembly from the compressor assembly with magnet clutch.
Remove the O-ring from the suction hose sub-assembly.
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
11.REMOVE COMPRESSOR ASSEMBLY WITH MAGNET CLUTCH
| *A | w/o Thermostat |
| *B | w/ Thermostat |
Disconnect the connector.
Detach the clamp.
| *A | w/o Thermostat |
| *B | w/ Thermostat |
|
Bolt |
|
Nut |
Remove the 2 bolts and 2 nuts.
| *A | w/o Thermostat |
| *B | w/ Thermostat |
Using an E8 "TORX" socket wrench, remove the 2 stud bolts and compressor assembly with magnet clutch.
Remove the compressor assembly with magnet clutch from the vehicle with the stud bolt remaining in the compressor assembly with magnet clutch.