1.DRAIN TRANSFER OIL
37100
2.REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
33309C
3.REMOVE OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY
36115C
4.REMOVE TRANSFER EXTENSION HOUSING TYPE T OIL SEAL
Using SST, remove the transfer extension housing type T oil seal.
Be careful not to damage the transfer extension housing type T oil seal and extension housing contact surface.
36115C
5.INSTALL TRANSFER EXTENSION HOUSING TYPE T OIL SEAL
Coat the lip of a new transfer extension housing type T oil seal with MP grease.
Using SST and a hammer, install the transfer extension housing type T oil seal as shown in the illustration.
48.5 to 49.5 mm (1.910 to 1.948 in.)
Be careful not to damage the transfer extension housing type T oil seal.
33309C
6.INSTALL OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY
37100
7.INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
8.ADD TRANSFER OIL
9.CHECK FOR TRANSFER OIL LEAK