Home › Drivetrain › VF2CM TRANSFER / 4WD / AWD › 4WD CONTROL ECU › 2015.06–2016.01
RM3250E _52 Drivetrain _038037 VF2CM TRANSFER / 4WD / AWD _0186295 4WD CONTROL ECU A

VF2CM TRANSFER / 4WD / AWD  4WD CONTROL ECU  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures(adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the 4 wheel drive control ECU removal /installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
ECM
for 1GR-FE:

Vehicle Identification Number (VIN) registration


DTC P0630 is output Click here(Click here)
for 2TR-FE:

Vehicle Identification Number (VIN) registration


DTC P0630 is output Click here(Click here)
for 1GD-FTV, 2GD-FTV:
·

Learning values save

·

Learning values write

·

Vehicle Identification Number (VIN) registration


·

Engine starting

·

DTC P0630 is output


for 1GD-FTV: Click here(Click here)
for 1GD-FTV, DPF: Click here(Click here)
for 2GD-FTV: Click here(Click here)
for 2GD-FTV, DPF: Click here(Click here)
for 1KD-FTV, 2KD-FTV:
·

Learning values save

·

Learning values write

·

Vehicle Identification Number (VIN) registration


Engine starting for 1KD-FTV: Click here(Click here)
for 2KD-FTV: Click here(Click here)
for RC60F, RC61F:

Performing iMT installation information reset


·

iMT system

·

DTCs are output


Click here(Click here)
Code registration (Immobiliser system) Engine start function See the Service Bulletin for the registration method.

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 89533 2.REMOVE 4 WHEEL DRIVE CONTROL ECU

a.
C331246

Remove the nut and 4 wheel drive control ECU.