Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
Use the same procedure for RHD and LHD vehicles.
The procedures listed below are for LHD vehicles.
A bolt without a torque specification is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
69318C
1.INSTALL DOOR LOCK WIRING HARNESS SEAL
When reusing a removed front door lock assembly LH, replace the door lock wiring harness seal with a new one.
Do not allow grease or dust to adhere to the door lock wiring harness seal installation surface.
Reusing a door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water ingress. This may result in a malfunction of the front door lock assembly LH.
|
Install in this Direction |
Install a new door lock wiring harness seal to the front door lock assembly LH.
69720B
2.INSTALL FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH
|
Install in this Direction |
Attach the guide to install the front door lock remote control cable assembly LH to the front door lock assembly LH.
69760C
3.INSTALL FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH
|
Install in this Direction |
Attach the guide to install the front door inside locking cable assembly LH to the front door lock assembly LH.
69036A
4.INSTALL FRONT DOOR LOCK COVER SUB-ASSEMBLY LH
Attach the clamp and claw to install the front door lock cover sub-assembly LH.
69320
5.INSTALL FRONT DOOR LOCK ASSEMBLY LH
Apply MP grease to the sliding parts of the front door lock assembly LH.
| *1 | Front Door Lock Open Rod LH |
|
Install in this Direction |
Connect the front door lock open rod LH to install the front door lock assembly LH as shown in the illustration.
Make sure that the front door lock open rod LH is securely connected to the front door lock assembly LH.
|
"Torx" Screw |
|
Connector |
Using a T30 "TORX" socket wrench, install the front door lock assembly LH with the 3 screws.
Connect the connector.
6.INSTALL FRONT DOOR OUTSIDE HANDLE COVER WITH LOCK CYLINDER ASSEMBLY (for Driver Side)
67404F
7.INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY LH
68102
8.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH
68151C
9.INSTALL FRONT DOOR GLASS RUN LH
67832
10.INSTALL FRONT DOOR SERVICE HOLE COVER LH
67602
11.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
69284C
12.INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH
13.INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side, w/ Power Window)
14.INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side, w/ Power Window)
69260
15.INSTALL FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)
74220
16.INSTALL FRONT ARMREST ASSEMBLY LH
67492A
17.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH
18.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
19.CHECK SRS WARNING LIGHT (w/ Curtain Shield Airbag)