Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
55607
1.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
87165C
2.REMOVE BLOWER MOTOR CONTROL
|
Screw |
|
Connector |
for Automatic Air Conditioning System, w/ Rear Resistor Duct:
Detach the clamp.
Disconnect the 2 connectors.
Remove the 2 screws and blower motor control.
|
Screw |
|
Connector |
for Automatic Air Conditioning System, w/o Rear Resistor Duct:
Disconnect the connector.
Remove the 2 screws and blower motor control.