Home › Engine / Hybrid System › 1GD-FTV ENGINE CONTROL › CRANKSHAFT POSITION SENSOR
RM3250E _51 Engine / Hybrid System _037972 1GD-FTV ENGINE CONTROL _0190021 CRANKSHAFT POSITION SENSOR A

1GD-FTV ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11401Q 1.INSTALL CRANKSHAFT POSITION SENSOR

a.

Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.


b.

Install the crankshaft position sensor with the bolt to the rear oil seal retainer.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

When reusing the crankshaft position sensor, check the O-ring.

·

Make sure that the O-ring is not cracked or jammed when installing to the rear oil seal retainer.

·

Replace with a new part if it is dropped or if it receives a strong impact.




Hide 2.INSTALL CRANKSHAFT POSITION SENSOR HARNESS BRACKET

a.

Install the crankshaft position sensor harness bracket with the bolt to the cylinder block sub-assembly.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 27148C 3.INSTALL CONNECTING WIRE

a.

Connect the 2 connectors and clamp and install the connecting wire.


Hide 12585 4.INSTALL NO. 5 CYLINDER BLOCK INSULATOR

Hide 12581A 5.INSTALL NO. 1 CYLINDER BLOCK INSULATOR

Hide 31250 8.INSTALL CLUTCH DISC ASSEMBLY (for Manual Transmission)

Hide 31210 9.INSTALL CLUTCH COVER ASSEMBLY (for Manual Transmission)