45250
1.INSTALL STEERING COLUMN ASSEMBLY
Install the steering column assembly with the 2 nuts and bolt.
Connect the connectors and attach the wire harness clamps.
45025D
2.INSTALL NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY
Install the steering column hole cover sub-assembly with the 3 bolts.
Install the bolts in the order shown in the illustration.
45219
3.CONNECT STEERING SLIDING YOKE
73900
4.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
5.INSTALL COMBINATION SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY
Attach the 3 claws to install the combination switch assembly with spiral cable sub-assembly to the steering column sub-assembly.
Connect the connectors to the combination switch assembly with spiral cable sub-assembly to the spiral cable assembly.
45286B
6.INSTALL STEERING COLUMN UPPER COVER
Attach the 2 claws and 2 guides to install the steering column upper cover.
45287
7.INSTALL STEERING COLUMN LOWER COVER
Attach the 2 claws and 6 guides to install the steering column lower cover.
Install the 3 screws.
45100
8.INSTALL STEERING WHEEL ASSEMBLY
9.PLACE FRONT WHEELS FACING STRAIGHT AHEAD
28800
10.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
11.CHECK SRS WARNING LIGHT
for Type A: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type A)>DIAGNOSIS SYSTEM
for Type B: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>DIAGNOSIS SYSTEM