11401Q
1.INSTALL CRANKSHAFT POSITION SENSOR
Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.
Install the crankshaft position sensor with the bolt to the rear oil seal retainer.
When reusing the crankshaft position sensor, check the O-ring.
Make sure that the O-ring is not cracked or jammed when installing to the rear oil seal retainer.
Replace with a new part if it is dropped or if it receives a strong impact.
2.INSTALL CRANKSHAFT POSITION SENSOR HARNESS BRACKET
Install the crankshaft position sensor harness bracket with the bolt to the cylinder block sub-assembly.
27148C
3.INSTALL CONNECTING WIRE
Connect the 2 connectors and clamp and install the connecting wire.
12585
4.INSTALL NO. 5 CYLINDER BLOCK INSULATOR
12581A
5.INSTALL NO. 1 CYLINDER BLOCK INSULATOR
11355
6.INSTALL REAR END PLATE
13405
7.INSTALL FLYWHEEL SUB-ASSEMBLY
31250
8.INSTALL CLUTCH DISC ASSEMBLY (for Manual Transmission)
for R151
Click hereDrivetrain>CLUTCH>CLUTCH UNIT(for R151)>INSTALLATION
for RC60, RC60F
Click hereDrivetrain>CLUTCH>CLUTCH UNIT(for RC60, RC61)>INSTALLATION
31210
9.INSTALL CLUTCH COVER ASSEMBLY (for Manual Transmission)
for R151
Click hereDrivetrain>CLUTCH>CLUTCH UNIT(for R151)>INSTALLATION
for RC60, RC60F
Click hereDrivetrain>CLUTCH>CLUTCH UNIT(for RC60, RC61)>INSTALLATION
10.INSTALL AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)
11.INSTALL MANUAL TRANSMISSION ASSEMBLY (for Manual Transmission)