Home › Engine / Hybrid System › 2KD-FTV COOLING › WATER PUMP
RM3250E _51 Engine / Hybrid System _038018 2KD-FTV COOLING _0192326 WATER PUMP A

2KD-FTV COOLING  WATER PUMP  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the parts in the following chart (A), replace the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly, No. 3 injection pipe sub-assembly, No. 4 injection pipe sub-assembly and/or fuel inlet pipe sub-assembly with new ones.

Replaced Parts (A) Pipes Requiring New Replacement
·

Injector assembly (including shuffling the injector assemblies between the cylinders)

·

Common rail assembly

·

Cylinder head sub-assembly


·

No. 1 injection pipe sub-assembly

·

No. 2 injection pipe sub-assembly

·

No. 3 injection pipe sub-assembly

·

No. 4 injection pipe sub-assembly


·

Supply pump assembly

·

Common rail assembly

·

Cylinder block sub-assembly

·

Cylinder head sub-assembly

·

Cylinder head gasket

·

Timing Gear Case Assembly


Fuel inlet pipe sub-assembly

·

After removing the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly, No. 3 injection pipe sub-assembly, No. 4 injection pipe sub-assembly and fuel inlet pipe sub-assembly, clean them with a brush and compressed air.



PROCEDURE

Hide 16100 1.INSTALL ENGINE WATER PUMP ASSEMBLY

a.

Install a new gasket and the engine water pump assembly with the 5 bolts and 2 nuts.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)


Hide 13505 4.INSTALL NO. 1 TIMING BELT IDLER SUB-ASSEMBLY

Hide 11322A 6.INSTALL NO. 1 TIMING BELT COVER

Hide 11201 7.INSTALL CYLINDER HEAD COVER SUB-ASSEMBLY

Hide 23704 8.INSTALL NO. 4 INJECTION PIPE SUB-ASSEMBLY

Hide 23701 9.INSTALL NO. 1, NO. 2 AND NO. 3 INJECTION PIPE SUB-ASSEMBLY

Hide 16620 10.INSTALL V-RIBBED BELT TENSIONER ASSEMBLY

Hide 88320 14.CONNECT COOLER COMPRESSOR ASSEMBLY (w/ Air Conditioning System)

Hide 16711 15.INSTALL FAN SHROUD

Hide 16470 16.INSTALL RADIATOR RESERVOIR

Hide 44369A 17.INSTALL OIL RESERVOIR BRACKET

Hide 44360 18.CONNECT VANE PUMP OIL RESERVOIR ASSEMBLY

Hide 16571C 19.INSTALL NO. 1 RADIATOR HOSE

Hide 21.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 51410 27.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY (for 4WD and Pre-Runner)