Home › Engine / Hybrid System › 1KD-FTV ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL
RM3250E _51 Engine / Hybrid System _037989 1KD-FTV ENGINE MECHANICAL _0193246 REAR CRANKSHAFT OIL SEAL A

1KD-FTV ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear engine oil seal removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
for A750F:
·

Automatic transmission assembly

·

Transmission valve body assembly

·

Any of the shift solenoid valves


Reset memory
·

Large shift shock

·

Engine overruns


(Click here)
for A750F:

Automatic transmission fluid


ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly
w/ Automatic Headlight Beam Level Control System:

The vehicle height changes due to replacement of suspension components or after performing such operations as removal and reinstallation


Headlight leveling ECU assembly initialization Headlight leveling function (Click here)
Front wheel alignment adjustment
·

Clearing zero point calibration data

·

Yaw rate and acceleration sensor zero point calibration


VSC malfunctioning (Click here)

PROCEDURE

Hide 33030 1.REMOVE MANUAL TRANSMISSION UNIT ASSEMBLY (for Manual Transmission)

Hide 2.REMOVE AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)

Hide 31210 3.REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission)

Hide 31250 4.REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)

Hide 13405 5.REMOVE FLYWHEEL SUB-ASSEMBLY

Hide 11381A 7.REMOVE REAR ENGINE OIL SEAL

a.
A352054C01
0.229,1.656 0.417,1.469 0.417,1.469 0.5,1.469 false 1.042,1.844 1.229,1.99 1.229,1.99 1.313,1.99 false 0.25,0.667 0.417,0.729 0.417,0.729 0.5,0.729 true 0.521,1.354 0.833,1.552 0.313,0.198 10 false *a 1.344,1.885 1.656,2.083 0.313,0.198 10 false *a 0.521,0.625 0.833,0.823 0.313,0.198 10 false *a
*a Cut Position


Using a knife, cut off the lip of the rear engine oil seal.


b.

Using a cloth and screwdriver, pry out the rear engine oil seal from the rear engine oil seal retainer.

NOTICE:

Be careful not to damage the crankshaft and rear engine oil seal retainer.


HINT:
·

After removal, check the crankshaft for damage. If damaged, smooth the surface with #400 sandpaper.

·

Tape the screwdriver tip before use.