When replacing the parts in the following chart (A), replace the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly, No. 3 injection pipe sub-assembly, No. 4 injection pipe sub-assembly and/or fuel inlet pipe sub-assembly with new ones.
| Replaced Parts (A) | Pipes Requiring New Replacement |
|---|---|
·
Injector assembly (including shuffling the injector assemblies between the cylinders) ·
Common rail assembly ·
Cylinder head sub-assembly |
·
No. 1 injection pipe sub-assembly ·
No. 2 injection pipe sub-assembly ·
No. 3 injection pipe sub-assembly ·
No. 4 injection pipe sub-assembly |
·
Supply pump assembly ·
Common rail assembly ·
Cylinder block sub-assembly ·
Cylinder head sub-assembly ·
Cylinder head gasket ·
Timing Gear Case Assembly |
Fuel inlet pipe sub-assembly |
After removing the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly, No. 3 injection pipe sub-assembly, No. 4 injection pipe sub-assembly and fuel inlet pipe sub-assembly, clean them with a brush and compressed air.
15710
1.INSTALL OIL COOLER ASSEMBLY
Install 2 new gaskets to the oil cooler assembly.
Install the oil cooler assembly to the oil cooler cover sub-assembly with the 4 nuts.
15701C
2.INSTALL OIL COOLER COVER SUB-ASSEMBLY
Install a new gasket and the oil cooler cover sub-assembly with the 13 bolts.
Connect the No. 2 vacuum transmitting pipe sub-assembly with the 2 nuts.
Connect the connector to the engine oil pressure switch assembly.
15601
3.INSTALL OIL FILTER SUB-ASSEMBLY
28100
4.INSTALL STARTER ASSEMBLY
23810A
5.INSTALL COMMON RAIL ASSEMBLY
22100
6.INSTALL FUEL SUPPLY PUMP ASSEMBLY
7.ADD ENGINE OIL
8.BLEED AIR FROM FUEL SYSTEM
9.ADD ENGINE COOLANT
10.INSPECT FOR COOLANT LEAK
11.INSPECT FOR FUEL LEAK
12.INSPECT FOR OIL LEAK
51410
13.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY