Home › Drivetrain › A750F AUTOMATIC TRANSMISSION / TRANSAXLE › TRANSMISSION WIRE
RM3250E _52 Drivetrain _038029 A750F AUTOMATIC TRANSMISSION / TRANSAXLE _0193341 TRANSMISSION WIRE A

A750F AUTOMATIC TRANSMISSION / TRANSAXLE  TRANSMISSION WIRE  REMOVAL  


PROCEDURE

Hide 1.DRAIN AUTOMATIC TRANSMISSION FLUID

a.

Remove the drain plug and gasket from the automatic transmission assembly, and drain the ATF.


b.

Install a new gasket and the drain plug to automatic transmission assembly.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)


Hide 2.SUPPORT AUTOMATIC TRANSMISSION ASSEMBLY

a.
C324232

Support the automatic transmission assembly with a transmission jack.


Hide 51204 3.REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY

Hide 35106 5.REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

a.
C324038

Remove the 20 bolts, automatic transmission oil pan sub-assembly and gasket from the automatic transmission assembly.

NOTICE:

Some fluid will remain in the automatic transmission oil pan sub-assembly. Remove all the oil pan bolts, and carefully remove the automatic transmission oil pan sub-assembly.



b.

Examine the particles in the automatic transmission oil pan sub-assembly.

i.

Remove the 4 magnets and use them to collect steel particles. Carefully inspect the foreign matter and particles in the pan and on the magnets to anticipate the type of wear you will find in the automatic transmission assembly.

Steel (magnetic): Bearing, gear and clutch plate wear

Brass (non-magnetic): Bush wear



Hide 35330 6.REMOVE VALVE BODY OIL STRAINER ASSEMBLY

a.
C324039

Remove the 4 bolts and valve body oil strainer assembly.

NOTICE:

Be careful as some fluid may leak out of the valve body oil strainer assembly.



b.

Remove the O-ring from the valve body oil strainer assembly.


Hide 82121 7.DISCONNECT ENGINE WIRE

a.
C283569

Disconnect the engine wire from the transmission wire.

HINT:

Detach the claw, press down the lever, and disconnect the engine wire connector.



Hide 82125J 8.REMOVE TRANSMISSION WIRE

C125285

a.

Remove the 2 bolts and 2 temperature sensor clamps.


b.

Disconnect the 2 ATF temperature sensors.


c.

Disconnect the 7 connectors from the solenoid valves.


d.
C324064

Remove the bolt and pull out the transmission wire from the automatic transmission case sub-assembly.


e.

Remove the O-ring from the transmission wire connector.