The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the injection pump assembly removal/installation are shown below.
13568
1.REMOVE TIMING BELT
26100
2.REMOVE VENTURI ASSEMBLY
23701
3.REMOVE INJECTION PIPE SUB-ASSEMBLY
13613P
4.REMOVE INJECTION PUMP DRIVE PULLEY
Using SST, remove the nut.
Using SST, remove the injection pump drive pulley from the injection pump assembly.
22100
5.REMOVE INJECTION PUMP ASSEMBLY
Slide the 3 clamps and disconnect the 3 fuel hoses from the injection pump assembly.
Disconnect the 7 connectors and detach the wire harness clamp.
| *a | Mark (Timing Gear Case Sub-assembly Side) |
| *b | Mark (Injection Pump Assembly Side) |
Remove the 3 bolts and No. 1 injection pump stay from the cylinder block sub-assembly and injection pump assembly.
Before removing the injection pump assembly, check if the marks are aligned.
If not, place new marks for reinstallation.
Remove the 2 nuts and injection pump assembly from the timing gear case sub-assembly.