22100
1.INSTALL INJECTION PUMP ASSEMBLY
Temporarily install the injection pump assembly to the timing gear case sub-assembly with the 2 nuts.
Temporarily install the No. 1 injection pump stay to the cylinder block sub-assembly and injection pump assembly with the 3 bolts.
| *a | Mark (Timing Gear Case Sub-assembly Side) |
| *b | Mark (Injection Pump Assembly Side) |
Rotate the injection pump assembly body to align the marks on the injection pump assembly flange and timing gear case sub-assembly.
Tighten the 2 nuts.
Tighten the 3 bolts.
Connect the 7 connectors and attach the wire harness clamp.
Connect the 3 fuel hoses to the injection pump assembly, and slide the 3 clamps to secure the hoses.
13613P
2.INSTALL INJECTION PUMP DRIVE PULLEY
Using SST, install the injection pump drive pulley to the injection pump assembly with the nut.
23701
3.INSTALL INJECTION PIPE SUB-ASSEMBLY
26100
4.INSTALL VENTURI ASSEMBLY
13568
5.INSTALL TIMING BELT
6.BLEED AIR FROM FUEL SYSTEM