Home › Engine / Hybrid System › 5L-E FUEL › FUEL FILTER › from 2016.01
RM3250E _51 Engine / Hybrid System _049912 5L-E FUEL _0242565 FUEL FILTER A

5L-E FUEL  FUEL FILTER  REPLACEMENT  


CAUTION / NOTICE / HINT

HINT:
·

When replacing the fuel filter element assembly, use TOYOTA genuine parts.

·

When replacing the fuel filter element assembly, clean the fuel filter case and remove dirt completely.



PROCEDURE

Hide 23390 1.REMOVE FUEL FILTER ELEMENT ASSEMBLY

HINT:

Replacement of the fuel filter element assembly can be performed with the fuel filter assembly installed to the fuel filter bracket.


a.
A347376C01
1.708,1.917 1.708,1.219 true 1.625,1.927 1.875,2.115 0.25,0.188 10 true *1 3.031,0.948 3.25,1.135 0.219,0.188 10 false 1 2.708,1.604 2.927,1.792 0.219,0.188 10 false 2
*1 Lead Wire


Disconnect the clamp and slide the lead wire as shown in the illustration to remove it.


b.
A347377

Disconnect the level warning switch connector.


c.
A347378

Slide the fuel filter assembly and lift it up.


d.
A347379C01
0.604,1.635 0.604,0.948 true 2.719,1.865 2.51,1.865 2.51,1.865 2.031,1.365 true 0.521,1.656 0.833,1.813 0.313,0.156 10 false *1 2.75,1.771 3.052,2.01 0.302,0.24 10 true *2
*1 Drain Cock
*2 Hose


Connect a hose to the drain cock. Place the other end of the hose into a container under the drain cock.


e.

Loosen the drain cock to drain fuel.


f.

Tighten the drain cock by hand.


g.

Disconnect a hose from the drain cock.


h.
A339530

Disconnect the clogging switch connector.


i.
A339527

Using a screwdriver as a lever, loosen the fastener nut until it can be loosened by hand.


j.
A339528

Fully loosen the fastener nut by hand.


k.
A339532C01
2.208,1.083 2.656,1.083 true 2.729,1 2.948,1.198 0.219,0.198 10 false *1
*1 O-ring


To remove the fuel filter cap, pull up one side of the fuel filter cap, and then lift it off.


l.

Remove the fuel filter element assembly from the fuel filter case.


m.

Remove the O-ring from the fuel filter case.


Hide 23390 2.INSTALL FUEL FILTER ELEMENT ASSEMBLY

a.

Clean the fuel filter case and remove dirt completely.


b.
A339533C01
0.271,1.042 0.542,1.042 true 1.698,0.448 1.823,0.448 1.823,0.448 2.104,0.75 true 0.052,0.958 0.25,1.125 0.198,0.167 10 true *1 1.51,0.354 1.688,0.521 0.177,0.167 10 true *2
*1 O-ring
*2 Fuel Filter Element Assembly


Install a new O-ring to the fuel filter case.


c.

Install the fuel filter element assembly to the fuel filter case.


d.
A339534

Align the mark on the fuel filter cap and the mark on the fuel filter case.


e.
A339535N01
2.844,3.844 3.031,4.031 0.188,0.188 10 true A

Push the fuel filter cap onto the fuel filter case by hand.

Standard clearance (A):

1.5 mm (0.0590 in.) or less


HINT:

The clearance between the fuel filter cap and fuel filter case should be even around the entire circumference of the fuel filter cap and fuel filter case.



f.
A339536N01
1.594,4.354 1.792,4.542 0.198,0.188 10 true A 3.26,3.208 3.417,3.365 0.156,0.156 10 true B

Turn the fastener nut until a "click" sound is heard.

HINT:

Just before the marks of the fuel filter case and nut align, the fastener nut will become more difficult to turn. Use a screwdriver as a lever to turn the fastener nut.



g.

Measure the distance between the marks on the fuel filter cap and fuel filter case, and the clearance between the fuel filter cap and fuel filter case.

Standard distance (A):

1.0 mm (0.0393 in.) or more


Standard clearance (B):

1.0 mm (0.0393 in.) or less



h.

Connect the clogging switch connector.


i.
A347380

Slide the fuel filter assembly to install it.


j.
A347381C01
1.771,1.875 1.771,1.219 true 1.698,1.885 1.979,2.094 0.281,0.208 10 true *1 3.042,0.979 3.198,1.177 0.156,0.198 10 false 2 2.604,1.688 2.76,1.885 0.156,0.198 10 false 1
*1 Lead Wire


Attach the clamp and slide the lead wire as shown in the illustration to install it.


Hide 3.RESET FUEL SYSTEM WARNING LIGHT

a.

Turn the ignition switch to ON.


b.
A339670

After turning the ignition switch to ON, connect the level warning switch connector no sooner than 3 seconds have passed but no later than 60 seconds have passed.


c.

Check that the combination meter fuel system warning light turns off.