The ECM and generator assembly each detect reception malfunctions. A generator assembly reception malfunction detected by the generator assembly is sent to the ECM via LIN communication. If there is a malfunction in either the ECM or generator assembly, the ECM determines that there is a LIN communication malfunction and outputs a DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory |
|---|---|---|---|---|
| P161A | Lost Communication with Alternator | Diagnosis condition: Ignition switch to ON
When the ECM cannot receive LIN communication, the generator assembly cannot receive LIN communication for approximately 17 minutes or more. Other: 1 trip |
·
Generator assembly ·
ECM ·
Wire harness or connector |
DTC stored |
Check the charging system.
Click herePower Source / Network>1TR-FE BATTERY / CHARGING>CHARGING SYSTEM>ON-VEHICLE INSPECTION
| Result |
|---|
| OK |
| NG |
OK
NG
Disconnect the C53 ECM connector.
Disconnect the C9 generator assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C53-16 (LIN) - C9-2 (LIN) | Always | Below 1 Ω |
| C53-16 (LIN) or C9-2 (LIN) - Body ground | Ignition switch off
(while LIN communication is stopped) |
10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Inspect the generator assembly.
for 80A Type
Click herePower Source / Network>1TR-FE BATTERY / CHARGING>GENERATOR(for 80A Type)>INSPECTION
for 90A Type
Click herePower Source / Network>1TR-FE BATTERY / CHARGING>GENERATOR(for 90A Type)>INSPECTION
| Result |
|---|
| OK |
| NG |
OK
NG
for 80A Type
Click herePower Source / Network>1TR-FE BATTERY / CHARGING>GENERATOR(for 80A Type)>REMOVAL
for 90A Type
Click herePower Source / Network>1TR-FE BATTERY / CHARGING>GENERATOR(for 90A Type)>REMOVAL