Home › Power Source / Network › 1GD-FTV BATTERY / CHARGING › CHARGING SYSTEM › from 2016.01
RM3250E _57 Power Source / Network _038055 1GD-FTV BATTERY / CHARGING _0195911 CHARGING SYSTEM C

1GD-FTV BATTERY / CHARGING  CHARGING SYSTEM  P161A  Lost Communication with Alternator  


DESCRIPTION

The ECM and generator assembly each detect reception malfunctions. A generator assembly reception malfunction detected by the generator assembly is sent to the ECM via LIN communication. If there is a malfunction in either the ECM or generator assembly, the ECM determines that there is a LIN communication malfunction and outputs a DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Memory
P161A Lost Communication with Alternator Diagnosis condition:
·

Ignition switch ON


Malfunction status:
·

When the ECM cannot receive LIN communication, the generator assembly cannot receive LIN communication for approximately 17 minutes or more.


Other:
·

1 trip


·

Generator assembly

·

ECM

·

Wire harness or connector


Displayed DTC stored

WIRING DIAGRAM

E221308E16
1.792,0.833 2.25,1.031 0.458,0.198 10 false 2 0.667,1.667 1.125,1.865 0.458,0.198 10 false C8 1.458,1.021 1.917,1.219 0.458,0.198 10 false LIN 0.667,1.833 2,2.083 1.333,0.25 10 false Generator Assembly 5.375,0.833 5.833,1.031 0.458,0.198 10 false 7 5.667,1.031 6.125,1.229 0.458,0.198 10 false LIN 5.833,1.833 6.292,2.031 0.458,0.198 10 false C60 5.833,2 6.292,2.198 0.458,0.198 10 false ECM 0.917,2.354 2.542,2.552 1.625,0.198 10 false : LIN Communication Line

PROCEDURE

1.CHECK CHARGING SYSTEM

Result:
Result
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (ECM - GENERATOR ASSEMBLY)

NG

REPAIR OR REPLACE CHARGING SYSTEM

2.CHECK HARNESS AND CONNECTOR (ECM - GENERATOR ASSEMBLY)
a.

Disconnect the C60 ECM connector.


b.

Disconnect the C8 generator assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
C60-7 (LIN) - C8-2 (LIN) Always Below 1 Ω
C60-7 (LIN) or C8-2 (LIN) - Body ground Ignition switch off
(while LIN communication is stopped)
10 kΩ or higher



Result:
Proceed to
OK
NG



OK

3.INSPECT GENERATOR ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR