Home › Engine / Hybrid System › 1TR-FE ENGINE CONTROL › CRANKSHAFT POSITION SENSOR › from 2016.01
RM3250E _51 Engine / Hybrid System _037997 1TR-FE ENGINE CONTROL _0181528 CRANKSHAFT POSITION SENSOR A

1TR-FE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  REMOVAL  


PROCEDURE

Hide 51410 1.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY (w/ Air Conditioning System)

Hide 16361A 2.REMOVE FAN AND GENERATOR V BELT (w/ Air Conditioning System)

Hide 53735B 3.REMOVE FRONT UPPER FENDER APRON SEAL LH (w/ Air Conditioning System)

Hide 88320 4.DISCONNECT COOLER COMPRESSOR ASSEMBLY (w/ Air Conditioning System)

a.
A345922

Remove the bolt and disconnect the suction hose sub-assembly from the timing chain cover sub-assembly.


b.
A345923

Disconnect the cooler compressor connector.


c.

Remove the 2 bolts and 2 nuts.


d.
E316308

Using an E8 "TORX" socket wrench, remove the 2 stud bolts and disconnect the cooler compressor assembly.


e.

Support the cooler compressor assembly securely.

HINT:

It is not necessary to completely remove the cooler compressor assembly. With the hoses connected to the cooler compressor assembly, hang the cooler compressor assembly on the vehicle body with a rope.



Hide 88431 5.REMOVE NO. 1 COMPRESSOR MOUNTING BRACKET (w/ Air Conditioning System)

Hide 11301K 6.REMOVE CRANKSHAFT POSITION SENSOR

a.
A345924

Disconnect the crankshaft position sensor connector.


b.

Disconnect the crankshaft position sensor connector from the connector bracket.


c.

Detach the harness clamp.


d.

Remove the bolt and crankshaft position sensor.