Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR DOOR BELT MOULDING › from 2016.03
RM3250E _59 Vehicle Exterior _038080 EXTERIOR PANELS / TRIM _0184367 REAR DOOR BELT MOULDING A

EXTERIOR PANELS / TRIM  REAR DOOR BELT MOULDING  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the rear door belt moulding assembly removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative battery terminal Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system (Click here)
Memorize steering angle neutral point Pre-crash safety system (Click here)

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

Fully open the rear door glass sub-assembly LH before proceeding with work.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 67674A 3.REMOVE REAR DOOR FRAME GARNISH LH

Hide 74260 4.REMOVE REAR ARMREST ASSEMBLY LH

Hide 5.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL (w/ Power Window)

Hide 69260E 6.REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

Hide 69284D 7.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH

Hide 67604 8.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 67842E 9.REMOVE REAR DOOR SERVICE HOLE COVER LH

Hide 68152C 10.REMOVE REAR DOOR GLASS RUN LH

Hide 67408E 11.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

Hide 68104 12.REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH

Hide 75740 13.REMOVE REAR DOOR BELT MOULDING ASSEMBLY LH

a.
B399262C01
0,0 0,0 false
V100155

Protective Tape


Put protective tape around the rear door belt moulding assembly LH.


b.
B399263C02
0,0 0,0 false
V113147

Remove in this Direction


Using moulding remover D, detach the claw and remove the rear door belt moulding assembly LH as shown in the illustration.