The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front floor side airbag sensor removal/installation are shown below.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type C)>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
67914
3.REMOVE FRONT DOOR SCUFF PLATE LH
for Single Cab:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Single Cab)>REMOVAL
for Double Cab:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Double Cab)>REMOVAL
for Smart Cab:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Smart Cab)>REMOVAL
67918A
4.REMOVE REAR DOOR SCUFF PLATE LH (for Double Cab)
62414A
5.REMOVE LOWER CENTER PILLAR GARNISH LH (for Double Cab)
89837
6.REMOVE FRONT FLOOR SIDE AIRBAG SENSOR
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If this procedure is performed without disconnecting the negative (-) terminal of the battery, the airbag may deploy even if an impact is applied only to the front floor side airbag sensor. Therefore, make sure that the negative (-) terminal of the battery is disconnected before performing this procedure.
Disconnect the airbag connector.
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
Push down the housing lock and slide the CPA. (At this time, the airbag connector cannot be disconnected yet.)
| *a | Housing Lock | *b | CPA |
| *c | CPA Upper Part | - | - |
Push down the housing lock again and disconnect the airbag connector.
Do not push down the upper part of the CPA shown in the illustration when disconnecting the airbag connector.
| *A | for Single Cab, Smart Cab |
| *B | for Double Cab |
Remove the nut.
Loosen the bolt while holding the front floor side airbag sensor because the front floor side airbag sensor guide is easily damaged.
Detach the guide and remove the front floor side airbag sensor.
If the front floor side airbag sensor has been dropped, replace it with a new one.